The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

GC+ Replacement Controller Board

Was: $17.50

Write a Review


NOTE: All units will have the dual tact resistors pre-soldered unless otherwise requested.



The GC+ Replacement Controller Board is a modern replacement for older controllers, designed to be smaller, better, and easier to use in your projects! Not only does it do everything the original controllers can do, but it also can be configured via software to fit your exact needs. You can adjust the sensitivity of the joysticks, invert each axis, or even change rumble intensity.



  • Complete controller functionality, including analog triggers and rumble
  • Compatible with 3DS sliders without an external converter
  • Compatible with PC USB adapters
  • Configurable via homebrew
  • Completely upgradeable!


What is the dual tact trigger system?

If you've ever used an original controller, you know that the shoulder buttons(L and R) are sensitive to how hard you press them, and click once they are fully pressed. This is an analog and digital trigger system, analog measuring the length of the press, and digital measuring the final "click." The dual tact trigger system allows the analog line to act as a digital one, meaning you can use a two "click" system, which is easier to implement than a full analog solution. So, instead of dealing with potentiometers and complex mounting systems, you can just solder up two buttons and you're good to go!


Related Documentation:

Full documentation here